Buick Regal 2018-2026 Service Manual / Suspension / Electronic Suspension Control / Repair Instructions
Buick Regal: Repair Instructions
- Electronic Suspension Control Module Replacement
- Rear Suspension 4 Corner Air Leveling Position Sensor Replacement (CNQ)
READ NEXT:
Electronic Suspension Control Module Replacement
Removal Procedure
1. Active Safety Control Module@Left Side - Remove.
2.
Remove the electronic suspension control module (2) by releasing the tab as
indicated on the
electronic suspension control m
Rear Suspension 4 Corner Air Leveling Position Sensor Replacement (CNQ)
Removal Procedure
1. Remove the rear tire and wheel assembly.
2. Separate the rear suspension 4 corner air leveling position sensor harness
clip from the underbody
rear side rail.
3. Electrical Co
Description and Operation
ELECTRONIC SUSPENSION CONTROL DESCRIPTION AND OPERATION
K19 - K19 Suspension Control Module
B161LF - B161LF Vertical Suspension Acceleration Sensor - Left Front
B161RF - B161RF Vertical Suspension Ac
SEE MORE:
Steering Wheel and Column
SPECIFICATIONS
FASTENER SPECIFICATIONS
Single Use Threaded Fastener/Component Tightening Specifications
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced
with NEW after removal.
Reusable Threaded Fastener Tightening Specifications
NOTE:
All fasteners listed in this
Water Pump Pulley Replacement (3.6L LGX)
Preliminary Procedure
Drive Belt Replacement.
Water Pump Pulley Bolt [4x]
CAUTION: Refer to Fastener Caution.
Tighten
10 N.m (89 lb in)
Water Pump Pulley
Procedure
1. Install the EN-46104 Water Pump Pulley Holding Tool onto the water
pump
pulley mounting holes.
2. Remove the wate
© 2019-2026 Copyright www.buregal6.com
