Buick Regal: Seat Adjustment
Manual Seats
Warning: You can lose control of the vehicle if you try to adjust a driver seat while the vehicle is moving.
Adjust the driver seat only when the vehicle is not moving.
.png)
To adjust a manual seat:
1. Pull up on the handle at the front of the seat.
2. Slide the seat to the desired position and release the handle.
3. Try to move the seat back and forth to be sure it is locked in place.
Seat Height Adjuster
.png)
If available, move the lever up or down to manually raise or lower the seat.
Power Seat Adjustment
.png)
To adjust a power seat, if equipped:
- Move the seat forward or rearward by sliding the control forward or rearward.
- Raise or lower the front part of the seat cushion by moving the front of the control up or down.
- Raise or lower the entire seat by moving the rear of the control up or down.
READ NEXT:
Lumbar Adjustment
Four-Way Shown, Two-Way
Similar
To adjust the lumbar support,
if equipped:
Press and hold the front or rear
of the control to increase or
decrease lumbar support.
If equipped, press and hold the
Reclining Seatbacks
Warning:
Sitting in a reclined position when
the vehicle is in motion can be
dangerous. Even when buckled
up, the seat belts cannot do
their job.
The shoulder belt will not be
against your body. Inst
Memory Seats
If equipped, memory seats allow two
drivers to save and recall their
unique seat positions for driving the
vehicle, and a shared exit position
for getting out of the vehicle. Other
feature positions
SEE MORE:
Model Coverage, Description & Operation
MODEL COVERAGE
Model Coverage
Regal 2011-19
Verano 2012-17
DESCRIPTION & OPERATION
NOTE: The TPMS sensor Relearn procedure must be performed after every
tire
rotation, BCM replacement, or sensor replacement.
TIRE PRESSURE MONITOR (TPM) SYSTEM
The tire pressure monitor system uses the instru
Theft Deterrent Module Replacement
Preliminary Procedure
Front Floor Console Replacement.
Theft Deterrent Module
Procedure
Disconnect the electrical connector.
Control Module References for programming and setup information, if
required.
IMMOBILIZER SYSTEM COMPONENT PROGRAMMING (WITHOUT BTM)
This procedure will learn t
© 2019-2026 Copyright www.buregal6.com
