Buick Regal 2018-2025 Owners Manual / Driving and Operating / Starting and Operating
Buick Regal: Starting and Operating
READ NEXT:
New Vehicle Break-In
Caution:
The vehicle does not need an
elaborate break-in. But it will
perform better in the long run if
you follow these guidelines:
Do not drive at any one
constant speed, fast or slow,
for the
Starting the Engine
Place the transmission in the
proper gear.
Caution:
If you add electrical parts or
accessories, you could change
the way the engine operates. Any
resulting damage would not be
covered by the vehicle
Engine Heater
The engine coolant heater,
if available, can help in cold weather
conditions at or below -18 ВєC (0 ВєF)
for easier starting and better fuel
economy during engine warm-up.
Plug in the coolant hea
SEE MORE:
Transfer Case Bracket Replacement (2.0L LTG)
Removal Procedure
1. Raise and support the vehicle. Lifting and Jacking the Vehicle.
NOTE: The drive shaft remains in the wheel hub.
2. Front Wheel Drive Half Shaft- Right Side@Transfer Case - Disconnect.
3.
Remove the 2 transfer case bracket to transfer case bolts (1).
4.
Transfer Case Bracket
Automatic Transmission Flex Plate Installation
Special Tools
EN-51760 Flywheel Holding Tool
EN-45059 Angle Meter
For equivalent regional tools, refer to Special Tools.
1.
CAUTION: This vehicle is equipped with torque-to-yield or single use
fasteners. Install a
NEW torque-to-yield or single use fastener when installing this component.
Fail
© 2019-2025 Copyright www.buregal6.com
