WATERLEAK TEST PREPARATION
GM vehicles are designed to operate under normal environmental
conditions.
The design criteria for sealing materials and components takes into
consideration the seali
BODY WATERLEAK REPAIR
WARNING: If the vehicle interior is exposed to moisture and becomes
soaked up to
the level of the sensing and diagnostic module (SDM), the SDM and SDM
harness connector must be
Removal Procedure
1. Raise and support the vehicle.
2.
Rear Stabilizer Shaft Link Nut(1)@Right Side - Remove.
3. Rear Stabilizer Shaft Link Bolt(2)@Right Side - Remove and DISCARD.
4.
Rear Stabilizer Shaft Link Nut(1)@Left Side - Remove.
5. Rear Stabilizer Shaft Link Bolt(2)@Left Side - Remove
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diagnostic Procedure Instructions provides an overview of each
diagnostic category.
DTC Descriptors
D