Specifications
FASTENER SPECIFICATIONS (OFF VEHICLE)
Single Use Non-Threaded Fasteners/Components
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced
with NEW
after rem
DISASSEMBLED VIEWS
Case and Associated Parts (1 of 2)
Transmission Control Module Bolt [3x]
Transmission Control Module
Manual Shift Shaft Seal
Transmission Fluid Filler Tube Plug
Transmission
General
Directive 76/756 EEC and ECE-Regulation 48 cover checking and aiming of
headlamps on vehicle.
Correct aiming of headlamps of vehicles should enable optimal road illumination
by the low beam, with
minimal glare to oncoming traffic. For this purpose the inclination of the light
beam in rel
The park brakes do not require calibration often. Park brake calibration may
be required after certain
service procedures are performed. Some of these procedures are as follows:
Park brake actuator replacement.
Rear brake pad replacement.
Rear brake rotor replacement.
Rear brake caliper replac