Buick Regal 2018-2026 Service Manual / Transmission / Automatic Transmission - Aisin AF50-8 (MRC) / Repair Instructions - Off Vehicle
Buick Regal: Repair Instructions - Off Vehicle
- Torque Converter Assembly Removal
- Manual Shift Detent Lever and Park Pawl Removal
- Low and Reverse Clutch Piston Installation
- Front Internal Gear Installation
- Torque Converter and Differential Housing Assembly Assemble
READ NEXT:
Torque Converter Assembly Removal
Torque Converter
TORQUE CONVERTER FLUID SEAL REMOVAL
Torque Converter Fluid Seal
Special Tools
EN-45000 Seal Remover
Equivalent regional tools: Refer to Special Tools
TRANSMISSION CONTROL
Manual Shift Detent Lever and Park Pawl Removal
Park Components Removal
Park Components Removal
Manual Shift Detent Bolt
Automatic Transmission Control Lever Detent Spring
Manual Shift Detent Lever Spring
Park Pawl Lockout Pin
Park Pawl Shaf
Low and Reverse Clutch Piston Installation
Direct Clutch Fluid Seal Ring [2x]
Direct Clutch Hub Thrust Bearing Race
2nd Clutch Housing Rear Bearing
Low and Reverse Clutch Application Ring
Low and Reverse Clutch Application Ring
Low and
SEE MORE:
Specifications, Schematic and Wiring Diagrams
Specifications
TEMPERATURE VERSUS RESISTANCE - INTAKE AIR TEMPERATURE S
TEMPERATURE VERSUS RESISTANCE - ENGINE COOLANT TEMPERATURE SENSOR
ALTITUDE VERSUS BAROMETRIC PRESSURE
IGNITION SYSTEM SPECIFICATIONS
FASTENER SPECIFICATIONS
Single Use Non-Threaded Fasteners/Components
NOTE: All fasteners/c
Front Wheel Drive Intermediate Shaft Replacement
Removal Procedure
1. Remove the tire and wheel assembly.
WARNING: To prevent personal injury and/or component damage, do not
allow the weight
of the vehicle to load the front wheels, or attempt to operate the vehicle, when
the wheel drive shaft(s) or wheel drive shaft nut(s) are removed. To do so m
© 2019-2026 Copyright www.buregal6.com
