Buick Regal 2018-2026 Service Manual / Steering & Driveline & Axle / Propeller Shaft
Buick Regal: Propeller Shaft
READ NEXT:
Specifications, Diagnostic Information and Procedures
SPECIFICATIONS
FASTENER SPECIFICATIONS
Single Use Non-Threaded Fasteners/Components
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced
with NEW
after removal.
Applicat
Repair Instructions
PROPELLER SHAFT REPLACEMENT
Special Tools
DT-51329 Drive Shaft Remover
GE-2619-A Slide Hammer
Equivalent regional tools:Special Tools.
Removal Procedure
1. Raise and support the vehicle.
2.
Floo
Description and Operation
PROPELLER SHAFT DESCRIPTION AND OPERATION
The function of the propeller shaft is to transfer power from the power
transfer unit to the differential clutch. It
consists of three tubes sections; the f
SEE MORE:
Stabilizer Shaft Replacement (FWD)
Removal Procedure
1. Raise and support the vehicle.
2.
Rear Stabilizer Shaft Link Nut(1)@Right Side - Remove.
3. Rear Stabilizer Shaft Link Bolt(2)@Right Side - Remove and DISCARD.
4.
Rear Stabilizer Shaft Link Nut(1)@Left Side - Remove.
5. Rear Stabilizer Shaft Link Bolt(2)@Left Side - Remove
DTC P0601, P0602, P0603, or P0604
Diagnostic Instructions
Perform the Diagnostic System Check prior to using this diagnostic
procedure: Refer to Diagnostic System
Check - Vehicle
Review the description of Strategy Based Diagnosis: Strategy Based
Diagnosis
An overview of each diagnostic category can be found here: Refer to
© 2019-2026 Copyright www.buregal6.com
