SPECIFICATIONS
FASTENER SPECIFICATIONS
Single Use Non-Threaded Fasteners/Components
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced
with NEW after removal.
Applicati
Removal Procedure
1. Heater and Air Conditioning Evaporator and Blower Module - Remove.
2.
{ If equipped }Auxiliary Heater Core(2) - Remove.
3.
Heater Core(1) - Remove.
4.
Heater and Air Conditioning Evaporator Case Bolt(1) - Remove[5x].
5.
Heater and Air Conditioning Evaporator Case(1) - Re
POWER TRANSFER UNIT CASE IDENTIFICATION
The power transfer unit primary identification label (1) is located on the
rear extension housing. The power transfer
unit secondary identification stamping (2) is located on the bottom of the main
housing.
Transfer Case Primary Identification Label
GM P