Buick Regal 2018-2025 Service Manual / Accessories and Equipment / Power Seats / Repair Instructions
Buick Regal: Repair Instructions
- Wire to Wire Repair - Seats
- Connector Reconnection - Seats
- Driver or Passenger Seat Adjuster Switch Replacement
READ NEXT:
Wire to Wire Repair - Seats
Special Tools
EL-38125-10 Splice Sleeve Crimping Tool
J-38125-5A Ultra Torch Special Tool
J-38125-8 Splice Sleeve Crimping Tool
For equivalent regional tools, refer to Special Tools.
WARNING: In
Connector Reconnection - Seats
Special Tools
EL-35616 Terminal Test Probe Kit
For equivalent regional tools, refer to Special Tools.
When the condition is not currently present, but is indicated in DTC history,
the cause may be
in
Driver or Passenger Seat Adjuster Switch Replacement
Preliminary Procedure
Front Seat Cushion Outer Finish Cover Replacement (Manual) or Front Seat
Cushion Outer
Finish Cover Replacement (Power).
Front Seat Recliner Knob
Front Seat Adjuster Knob
D
SEE MORE:
Rear Brake Hose Replacement (GNC)
Removal Procedure
WARNING: Brake Dust Warning
WARNING: Brake Fluid Irritant Warning
1. Raise and support the vehicle.
2. Remove the tire and wheel assembly.
3.
Brake Pipe Fitting(1) - Disconnect.
4. Cap the brake pipe fitting to prevent brake fluid loss and contamination.
5.
Brake Hose Retainer
Throttle Actuator Control (TAC) System Description
The engine control module (ECM) is the control center for the throttle
actuator control (TAC) system.
The ECM determines the driver's intent based on input from the accelerator pedal
position sensors, then
calculates the appropriate throttle response based on the throttle position
sensors. The
© 2019-2025 Copyright www.buregal6.com
