Removal Procedure
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the
Vehicle.
2.
NOTE:
When performing the following procedure, use only hand tools to
remove
and inst
Special Tools
DT-305-1 Driver Handle
DT-51466 Seal Installer
Equivalent regional tools: Special Tools
Removal Procedure
1. Raise and support the vehicle. Lifting and Jacking the Vehicle.
NOTE: The
Removal Procedure
1. Raise and support the vehicle. Lifting and Jacking the Vehicle.
NOTE: The drive shaft remains in the wheel hub.
2. Front Wheel Drive Half Shaft- Right Side@Transfer Case - Disconn
The brake master cylinder reservoir
is filled with GM approved DOT 4
brake fluid as indicated on the
reservoir cap.
Checking Brake Fluid
With the vehicle in P (Park) on a
level surface, the brake fluid level
should be between the minimum
and maximum marks on the brake
fluid reservoir.
There are on
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diagnostic Procedure Instructions provides an overview of each
diagnostic category.
Circuit/System De