Buick Regal 2018-2025 Service Manual / Transmission / Power Transfer Unit/Transfer Case - AAM
Buick Regal: Power Transfer Unit/Transfer Case - AAM
- Specifications
- Component Locator
- Diagnostic Information and Procedures
- Repair Instructions - On Vehicle
- Repair Instructions - Off Vehicle
- Description and Operation
- Special Tools and Equipment
READ NEXT:
Specifications
FASTENER SPECIFICATIONS
Single Use Non-Threaded Fasteners/Components
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced
with NEW
after removal.
Application
Power Trans
Component Locator
POWER TRANSFER UNIT CASE DISASSEMBLED VIEW
Power Transfer Unit Components
Power Transfer Unit Alignment Sleeve
Power Transfer Unit Face Seal - O-Ring
Power Transfer Unit Case
Power Transfer Unit
Diagnostic Information and Procedures
SYMPTOMS - POWER TRANSFER UNIT CASE
Strategy Based Diagnostics
Review the system operations in order to familiarize yourself with the system
functions. Refer to Power Transfer
Unit Case Disassembled
SEE MORE:
Transfer Case Fluid Replacement
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the
Vehicle.
2.
NOTE:
When performing the following procedure, use only hand tools to
remove
and install the drain and fill plugs.
Ensure that an approved drain pan is used when draining the
transfe
Engine Front Cover Installation
Special Tools
EN-45059 Angle Meter
EN-50820 Front Crankshaft Seal Installer
For equivalent regional tools, refer to Special Tools.
1.
Using EN-50820 installer, install the front crankshaft seal (1) into the
engine front cover.
2.
Ensure proper use of room temperature vulcanizing (RTV) sealan
© 2019-2025 Copyright www.buregal6.com
