Buick Regal Owners & Service Manuals

Buick Regal: Rear Suspension

Specifications

FASTENER SPECIFICATIONS

Single Use Threaded Fastener/Component Tightening Specifications

NOTE: All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.

Rear Suspension

Rear Suspension

NOTE: All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.

Rear Suspension

Rear Suspension

NOTE: All fasteners listed in this table can be reused after removal.

Rear Suspension

ADHESIVES, FLUIDS, LUBRICANTS, AND SEALERS

Rear Suspension

READ NEXT:

 Repair Instructions

 Rear Wheel Bearing and Hub Replacement (AWD)

Removal Procedure 1. Remove the rear tire and wheel assembly. 2. Rear Wheel Speed Sensor - Remove. 3. Rear Wheel Drive Shaft@Rear Wheel Bearing and Hub Assembly - Separate. Rear Wheel Drive Shaft

 Knuckle Replacement (FWD)

Removal Procedure 1. Remove the rear tire and wheel assembly. 2. Rear Brake Caliper Bracket - Remove. 3. Rear Brake Rotor - Remove. 4. Rear Brake Shield - Remove. 5. Rear Wheel Bearing and Hub As

SEE MORE:

 DTC P0627-P0629

Diagnostic Instructions Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Review Strategy Based Diagnosis for an overview of the diagnostic approach. Diagnostic Procedure Instructions provides an overview of each diagnostic category. DTC Descriptor DT

 Cylinder Head Removal

Special Tools EN 38188 Cylinder Head Broken Bolt Extractor Kit - or equivalent aftermarket tool For equivalent regional tools, refer to Special Tools. 1. Remove and discard the cylinder head bolts (1). CAUTION: In order to prevent damage to the valves and injectors during cylinder head removal,

© 2019-2026 Copyright www.buregal6.com