Buick Regal: Repair Instructions
- Rear Wheel Bearing and Hub Replacement (AWD)
- Knuckle Replacement (FWD)
- Stabilizer Shaft Replacement (FWD)
- Rear Shock Absorber Mount Replacement
- Adjust Link Replacement (FWD)
- Rear Spring Replacement (FWD)
- Rear Suspension Upper Lateral Link Replacement (FWD)
- Rear Suspension Lower Trailing Link Replacement
READ NEXT:
Rear Wheel Bearing and Hub Replacement (AWD)
Removal Procedure
1. Remove the rear tire and wheel assembly.
2. Rear Wheel Speed Sensor - Remove.
3. Rear Wheel Drive Shaft@Rear Wheel Bearing and Hub Assembly - Separate.
Rear Wheel Drive Shaft
Knuckle Replacement (FWD)
Removal Procedure
1. Remove the rear tire and wheel assembly.
2. Rear Brake Caliper Bracket - Remove.
3. Rear Brake Rotor - Remove.
4. Rear Brake Shield - Remove.
5. Rear Wheel Bearing and Hub As
Stabilizer Shaft Replacement (FWD)
Removal Procedure
1. Raise and support the vehicle.
2.
Rear Stabilizer Shaft Link Nut(1)@Right Side - Remove.
3. Rear Stabilizer Shaft Link Bolt(2)@Right Side - Remove and DISCARD.
4.
Rear Stabili
SEE MORE:
DTC B124B (IO5/IO6)
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Refer to Diagnostic Procedure Instructions for an overview of each
diagnostic category.
DTC Descripto
Aluminum Wheel Porosity Repair
1. Remove The Tire And Wheel.
2. Inflate The Tire To The Pressure Stated On The Tire Placard.
3. Submerge The Tire/Wheel Into A Water Bath In Order To Locate The Leak.
4. Using A Grease Pencil, Mark The Wheel To Indicate The Leak Areas.
5. Using A Grease Pencil, Mark The Tire At The Valve Stem
© 2019-2026 Copyright www.buregal6.com
