Buick Regal 2018-2026 Service Manual / Engine / Engine Mechanical - 2.0L (LTG) / Description and Operation
Buick Regal: Description and Operation
- Turbocharger System Description
- Crankcase Ventilation System Description
- Engine Component Description
- Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant
READ NEXT:
Turbocharger System Description
Turbocharger Description and Operation
A turbocharger is a compressor that is used to increase the power output of
an engine by increasing the mass of the
oxygen and therefore the fuel entering the e
Crankcase Ventilation System Description
General Description
A crankcase ventilation system is used to consume crankcase vapors in the
combustion process instead of venting
them to atmosphere. Fresh air from the intake system is supplied to
Engine Component Description
Engine Description
Cylinder Block
The cylinder block is constructed of aluminum alloy by precision
sand-casting. The block has 5 crankshaft bearings
with the thrust bearing located on the second bear
SEE MORE:
Supplemental Inflatable Restraints
SPECIFICATIONS
FASTENER SPECIFICATIONS
Reusable Threaded Fastener Tightening Specifications
NOTE:
All fasteners listed in this table can be reused after removal.
SCHEMATIC WIRING DIAGRAMS
SIR WIRING SCHEMATICS
Power, Ground, Serial Data, and Indicator
Passenger Presence System
Frontal Impact Sens
Repair Instructions
PROPELLER SHAFT REPLACEMENT
Special Tools
DT-51329 Drive Shaft Remover
GE-2619-A Slide Hammer
Equivalent regional tools:Special Tools.
Removal Procedure
1. Raise and support the vehicle.
2.
Floor Panel Tunnel Panel Front Brace(3) - Remove.
3.
Floor Panel Tunnel Panel Rear Brace(2) - Remove.
4
© 2019-2026 Copyright www.buregal6.com
