Buick Regal: Front Wheel Drive Shaft Outer Joint and Boot Replacement
Special Tools
J-42572 Drive Shaft Seal Clamp Pliers
Disassembly Procedure
1. Front Wheel Drive Half Shaft - Remove
- Front Wheel Drive Half Shaft Replacement - Left Side
- Front Wheel Drive Half Shaft Replacement - Right Side (AWD)Front Wheel Drive Half Shaft Replacement - Right Side (FWD)
2. Place the wheel drive shaft horizontally in a bench vise.
3.
.png)
Using a side cutter or other suitable tool, remove and DISCARD the CV boot clamps (1) from the outer CV boot.
4.
.png)
Using a suitable driver and a hammer, remove the CV joint (1) from the front wheel drive half shaft (2).
5.
.png)
Remove and DISCARD the CV boot (1) from the front wheel drive half shaft (2).
6.
.png)
Retaining Ring(1)@Front Wheel Drive Half Shaft(2) - Remove and DISCARD.
Assembly Procedure
1.
.png)
Retaining Ring(1)@Front Wheel Drive Half Shaft(2) - Install NEW.
2.
.png)
Install the NEW CV boot clamps (1) and the NEW CV boot (2) onto the front wheel drive half shaft (3).
3. Pack the CV joint with grease prior to installation. Insert grease into the NEW outer boot prior to connecting the boot to the joint.
4.
.png)
Using a block of wood and a hammer, install the CV Joint (1) onto the front wheel drive half shaft (2).
5.
.png)
Compress both CV boot clamps (1) using the J-42572 Drive Shaft Seal Clamp Pliers.
6. Front Wheel Drive Half Shaft - Install.
- Front Wheel Drive Half Shaft Replacement - Left Side
- Front Wheel Drive Half Shaft Replacement - Right Side (AWD)Front Wheel Drive Half Shaft Replacement - Right Side (FWD)
READ NEXT:
Rear Wheel Drive Shaft Outer Joint and Boot Replacement
Special Tools
J-42572 Drive Shaft Seal Clamp Pliers
Disassembly Procedure
1. Rear Wheel Drive Shaft - Remove
Rear Wheel Drive Shaft Replacement - Left Side
Rear Wheel Drive Shaft Replacement - Righ
Description and Operation
WHEEL DRIVE SHAFTS DESCRIPTION AND OPERATION
Wheel drive shafts are flexible assemblies consisting of an inner joint and
an outer constant velocity joint connected
by an axle shaft. The inner joint i
SEE MORE:
Engine Oil Pressure Light
Caution:
Lack of proper engine oil
maintenance can damage the
engine. Driving with the engine oil
low can also damage the engine.
The repairs would not be covered
by the vehicle warranty. Check
the oil level as soon as possible.
Add oil if required, but if the oil
level is within the operating ra
Transfer Case Fluid Replacement
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the
Vehicle.
2.
NOTE:
When performing the following procedure, use only hand tools to
remove
and install the drain and fill plugs.
Ensure that an approved drain pan is used when draining the
transfe
